\chapter{Mobile Device Procedure}
% When using the Stripe M2 Card Reader, a mobile device is required. 

This section has been removed due to the fact that the convention is using point of sale devices unmanaged by Westlinks.

\section{How to Use the iPad}

N/A
% One or more iPads may have been provided to this convention to be used for onsite point of sale\\ transactions. These devices have been pre-configured for your convention and should work with little effort.

% To use them, follow these steps:

% \begin{outline}[enumerate]
%     \1 Power on with the switch in the upper left corner. 
%     \1 Click the Home button. 
%     \1 Enter the passcode (061035).
%     \1 Open the "Collect" app. 
%     \1 Process an order using the instructions below.
% \end{outline}

\section{How to Use a Mobile Phone}

N/A
% If you do not have pre-configured devices, you will need to configure your mobile phone as described here.

% \begin{outline}[enumerate]
%     \1 Find and install the "Collect for Stripe" app on your mobile device's app store.
%     \1 Launch the app.
%     \1 Sign in using the Collect Account Sign-In (not Connect with Stripe).
%         \2 You will be provided the credentials for this.
%     \1 You are now ready to process purchases.
% \end{outline}


\section{Connecting to a Reader}

N/A
% \begin{outline}[enumerate]
    
%     \1 The first time you use the app you will see a prompt: “Connect Reader”. The next sequence of steps will be similar but not exactly to to this:
%         \2 Which type of reader?
%             \3 Bluetooth
%             \4 Stripe Reader M2 (this is the small white reader)
%             \3 Internet
%             \4 BBPOS WisePOS E (this is the larger black reader) 
%             \4 Stripe Reader s700 (not yet released as of this writing)
%         \2 Tap on the appropriate reader.
%         \2 Discovering
%         \2 System automatically selects the reader you chose.
%         \2 Select Location Veteran's Hall
%         \2 If no locations found click refresh
%         \2 Click Veteran's hall
%         \2 Now it should be loaded correctly
%         \2 Tap Continue.
%         \2 Connecting.
%         \2 You may see some details about the reader.
%         \2 Tap through until you get to main screen again.
% \end{outline}

\section{To change readers}

N/A
% \begin{outline}[enumerate]
%     \1 Tap on currently connected reader.
%     \1 Disconnect.
%     \1 Repeat the above steps.
% \end{outline}


