\chapter{Mobile Device Procedure}
When using the Stripe M2 Card Reader, a mobile device is required. 

\section{How to Use the iPad}

One or more iPads may have been provided to this convention to be used for onsite point of sale\\ transactions. These devices have been pre-configured for your convention and should work with little effort.

To use them, follow these steps:

\begin{outline}[enumerate]
    \1 Power on with the switch in the upper left corner. 
    \1 Click the Home button. 
    \1 Enter the passcode (061035).
    \1 Open the "Collect" app. 
    \1 Process an order using the instructions below.
\end{outline}

\section{How to Use a Mobile Phone}

If you do not have pre-configured devices, you will need to configure your mobile phone as described here.

\begin{outline}[enumerate]
    \1 Find and install the "Collect for Stripe" app on your mobile device's app store.
    \1 Launch the app.
    \1 Sign in using the Collect Account Sign-In (not Connect with Stripe).
        \2 You will be provided the credentials for this.
    \1 You are now ready to process purchases.
\end{outline}


\section{Connecting to a Reader}

\begin{outline}[enumerate]
    
    \1 The first time you use the app you will see a prompt: “Connect Reader”. The next sequence of steps will be similar but not exactly to to this:
        \2 Which type of reader?
            \3 Bluetooth
            \4 Stripe Reader M2 (this is the small white reader)
            \3 Internet
            \4 BBPOS WisePOS E (this is the larger black reader) 
            \4 Stripe Reader s700 (not yet released as of this writing)
        \2 Tap on the appropriate reader.
        \2 Discovering
        \2 System automatically selects the reader you chose.
        \2 Select Location Veteran's Hall
        \2 If no locations found click refresh
        \2 Click Veteran's hall
        \2 Now it should be loaded correctly
        \2 Tap Continue.
        \2 Connecting.
        \2 You may see some details about the reader.
        \2 Tap through until you get to main screen again.
\end{outline}

\section{To change readers}

\begin{outline}[enumerate]
    \1 Tap on currently connected reader.
    \1 Disconnect.
    \1 Repeat the above steps.
\end{outline}


